3DSOLEX - UM2+ 5- ICE Nozzle Kit W- 0.40 EVERLAST Ruby

This amazing kit contains: 5 nozzles for UM2+ / Matchless / Olsson / E3D: 0.25-0.40-0.60-0.80 ICE Brass nozzles + 0.40 Everlast Ruby

This great kit consists of 5 nozzles, for the UM2+ / Matchless / Olsson Block / E3D:
0.25-0.40-0.60-0.80 ICE Brass nozzles + 0.40 Everlast Ruby
All the nozzles are brass nozzles. Except for the EVERLAST Ruby 0.40, they are coated with a hard and slippery material which makes cleaning a lot easier, and helps prevent plastic stick and being carried around the print.

These nozzles are standard nozzles except the Everlast which has the “Matchless” design of heating the filament.
This enables higher printing speeds and / or lower temperature, which again helps against dripping.

The ICE nozzles look a bit irregular on the surface due to the treatment, but this quickly evens out and does not affect printing. The nozzles have a run-in period of 2 hours at 200C-225C, to harden, tempering the surface.
After that they should be used at mazh 265C. Higher temperatures than 265C will destroy the treatment and the nozzle is just like any other nozzle!

ONLY the Everlast is recommended for abrasive materials, the other nozzles will wear out quickly

På linket nedenfor, finder du en mappe med alt dokumentation for 3D printere, filamenter mv. Den vil løbende blive opdateret

Klik her og gå til dokumentation

Du kan få leveret din ordre til en valgfri GLS pakkeshop, privats- eller erhvervsadresse.

Vi leverer din ordre fragtfrit til en valgfri GLS pakkeshop, hvis du bestiller for over 399 kr.

Du har mulighed for at vælge afhentning i butik. Når du modtager en mail med at din ordre er færdig pakket, kan den afhentes indenfor vores åbningstider, som er mandag til torsdag 9-17.00 og fredag kl. 9-16.30 på vores adresse Amalienborgvej 57 i Nørresundby.

Vil du vide mere om vores returregler, læs dem her

Vi ser frem til din ordre 😍