E3D - Revo™ Micro Hotend - Single Nozzle Kit - 24V

Smaller, lighter and better than ever before.

The Revo Micro 24V HotEnd uses the smallest heatsink E3D has produced to date.

* Only 30 g

* Adaptable to Bowden or direct drive setups

* Maximum temperature 300°C

* Nozzle type: RapidChange Revo

Titanium-like performance. The special manufacturing process gives this aluminum HotEnd the strength and low thermal conductivity of titanium, without actually being titanium!

Ready for Revo. Change nozzles at room temperature with fingers only. No complex tools, no hot clamping. Revo nozzles are a factory-sealed nozzle and heat breaker in one, so they are easy to fit and do not leak material when in use.

New heat. A Revo HeaterCore heats up in seconds. It is also very safe. With a positive temperature coefficient (PTC), the Revo HeaterCore cannot melt at extreme temperatures: the current is reduced when it gets hotter, so the dangers are reduced in the event of a thermal runaway.

Runs cool, looks cool. With an anodized black heatsink, the Revo Micro not only runs cool - it looks cool too.

Flexible for any setup. The Revo Micro plays well with Bowden and direct drive setups, but its lightweight construction makes it an ideal choice for Bowden setups.

! ATTENTION!

* Does not include 3D printed mounts
* The Revo Micro fan must be connected using the 5V regulator unless connected directly to a 5V pin
* The set is supplied with 100 mm PTFE tube
* You may need to level your build plate after changing the nozzle

Kit includes:

- 1 x Revo Micro heatsink

- 1 x M12x1.5 nut

- 1 x 20x20x10 5V fan

- 1 x 24V to 5V regulator board

- 1 x Revo Micro fan duct

- 1 x Collet

- 1 x Collet clip

- 1 x Revo HeaterCore 24V

- 1 x Revo HeaterCore spring

- 1 x Extension cable kit

- 1 x 100mm PTFE

- 1 x 0.40mm brass Revo Nozzle

På linket nedenfor, finder du en mappe med alt dokumentation for 3D printere, filamenter mv. Den vil løbende blive opdateret

Klik her og gå til dokumentation

Du kan få leveret din ordre til en valgfri GLS pakkeshop, privats- eller erhvervsadresse.

Vi leverer din ordre fragtfrit til en valgfri GLS pakkeshop, hvis du bestiller for over 399 kr.

Du har mulighed for at vælge afhentning i butik. Når du modtager en mail med at din ordre er færdig pakket, kan den afhentes indenfor vores åbningstider, som er mandag til torsdag 9-17.00 og fredag kl. 9-16.30 på vores adresse Amalienborgvej 57 i Nørresundby.

Vil du vide mere om vores returregler, læs dem her

Vi ser frem til din ordre 😍