UltiMaker - Arduino Mega Ultimaker Shield Control Board

Aruino Mega Ultimaker Control Board

This board is for Arduino MEGA as Ultimaker UltiStepper drive and compatible with Pololu stepper driver boards. You can add as many stepper driver carriers as you need. It is very similar to other Pololu based electronic implementation- including RAMPS- but it can support up to five steppers (three for X- Y- Z- one for an extruder and one for any other function.) It is designed to run at a higher voltage than 12 volts- which allows you to put 90 Watts out of one MOSFET and run your stepper motors with more torque and higher maximum speeds. Feature: Plug in all motors with simple 4-way JST connectors. Made for Ultimaker's UltiStepper Driver. Compatible with Pololu stepper driver boards. Configurable step sizes by placing jumpers. 3 x 55 Amp MOSFET outputs (with LED indicators. Actual current capability limited by PCB and connectors). All pins are broken out for maximum extensibility. Runs from 15V to 19V. Three thermocouple inputs - or thermistor inputs. (The 100K thermistor is recommended). Has an IDC header for adding an LCD panel. Has a header for adding an SD card module. A toggle - switch for powering up / down the board. Easier to wire up thermocouples. Includes a 12V regulator for an (always on) fan to cool the electronics. A PWM output with power for LED arrays and other lighting. LCD backlight dimming can be software controlled. A serial I/O header for bluetooth and ethernet add-ons. Servo outputs for experimental setups. They need to be interrupted or software driven as the pins routed to the servo header I/O do not have PWM. Note: When the jumper (closer the VR-tube 7812TV) is connected- the power of Arduino MEGA Ultimaker Shield will also power up the Mega. Package included: 1 x Arduino MEGA Ultimaker shield control board

På linket nedenfor, finder du en mappe med alt dokumentation for 3D printere, filamenter mv. Den vil løbende blive opdateret

Klik her og gå til dokumentation

Du kan få leveret din ordre til en valgfri GLS pakkeshop, privats- eller erhvervsadresse.

Vi leverer din ordre fragtfrit til en valgfri GLS pakkeshop, hvis du bestiller for over 399 kr.

Du har mulighed for at vælge afhentning i butik. Når du modtager en mail med at din ordre er færdig pakket, kan den afhentes indenfor vores åbningstider, som er mandag til torsdag 9-17.00 og fredag kl. 9-16.30 på vores adresse Amalienborgvej 57 i Nørresundby.

Vil du vide mere om vores returregler, læs dem her

Vi ser frem til din ordre 😍