Fremragende | Baseret på 600+ anmeldelser
SpiderSpringSteel System - Ex Ultimaker 3 - 228x255mm
På lager
Leveringstid: 1-2 hverdage
Gratis fragt over 399 kr
Nem og billig retur
Kundeservice alle hverdage
Smart SpiderSpringSheet with mounted PEI.
Incl. Top and bottom plate (SpringSteel Sheet and magnetic base)
Size: 228x255mm
Fits to:
Ultimaker 3 /3 Extended
Qualities:
*Easy to install
*Easy to use
*Good adhesion - Does not require additional adhesives
*Easy to get your item off the build plate after printing
! ATTENTION ! If you are in doubt about what size building board you should have, measure your bed from edge to edge
This new and smart SpiderSpringSteel System consists of three parts.
One part consists of a magnetic plate, which must be attached to your workpiece plate. The second part consists of a removable flexible steel sheet, on which the third part is mounted, namely a piece of high-quality PEI. With this system, no additional adhesives are needed to make your item stick during printing.
Mount your new SpiderSpringSteel System and start printing. When your workpiece is finished, allow the workpiece plate to cool, then remove the plate and give it a gentle bend. You can then just "pop" the model off the blank. It's that easy!
We recommend that you keep your SpiderSpringSteel assault clean by wiping it down with 70-91% isopropyl alcohol to ensure that you wipe away any grease or other residue that may have accumulated on the surface. This will help greatly increase your surface adhesion.
The SpiderSpringSteel plate itself with mounted PEI can withstand more than 200°C. The magnetic plate can withstand up to 85°C when printing for a long time, where it can withstand up to 120°C for a short time.
Tekniske specifikationer
Brand
Spider
Vægt
0.3 kg
På linket nedenfor, finder du en mappe med alt dokumentation for 3D printere, filamenter mv. Den vil løbende blive opdateret
Du kan få leveret din ordre til en valgfri GLS pakkeshop, privats- eller erhvervsadresse.
Vi leverer din ordre fragtfrit til en valgfri GLS pakkeshop, hvis du bestiller for over 399 kr.
Du har mulighed for at vælge afhentning i butik. Når du modtager en mail med at din ordre er færdig pakket, kan den afhentes indenfor vores åbningstider, som er mandag til torsdag 9-17.00 og fredag kl. 9-16.30 på vores adresse Amalienborgvej 57 i Nørresundby.
Vil du vide mere om vores returregler, læs dem her
Vi ser frem til din ordre 😍
Kundeservice
Email: info@3deksperten.dk
Telefon: +45 30 20 22 17
Mandag til torsdag: 9:00 - 17:00
Fredag: 9:00 - 16.30