SpiderPowderSpringSteel System - Ex. Ender-7 - 280x280mm

Smart SpiderPOWDERSpringSteel Sheet System with mounted PEI.

Incl. Top and bottom plate (PowderSpringSteel Sheet and magnetic base)

Size: 280x280mm - Fits Ex. to Ender-7

Qualities:

*Easy to install

*Easy to use

*Good adhesion - Does not require additional adhesives

*Easy to get your item off the build plate after printing

! ATTENTION ! If you are in doubt about what size building board you should have, measure your bed from edge to edge

This new and smart SpiderPowderSpringSteel Sheet System consists of three parts.

1.) One part consists of a magnetic plate which must be attached to your workpiece plate.

2.) The second part consists of a removable flexible steel sheet,

3.) on which the third part is mounted, namely a piece of high quality powder coated PEI.

With this system, no additional adhesives are needed to make your item stick during printing.

Mount your new SpiderPowderSpringSteel Sheet System and start printing. When your workpiece is finished, allow the workpiece plate to cool, then remove the plate and give it a gentle bend. You can then just "pop" the model off the blank. It's that easy!

We recommend that you keep your SpiderPowderSpringSteel assault clean by wiping it down with 70-91% isopropyl alcohol to ensure that you wipe away any grease or other residue that may have accumulated on the surface. This will help greatly increase your surface adhesion.

The Spider Powder SpringSteel plate itself with mounted PEI can withstand more than 200°C. The magnetic plate can withstand up to 85°C when printing for a long time, where it can withstand up to 120°C for a short time.

På linket nedenfor, finder du en mappe med alt dokumentation for 3D printere, filamenter mv. Den vil løbende blive opdateret

Klik her og gå til dokumentation

Du kan få leveret din ordre til en valgfri GLS pakkeshop, privats- eller erhvervsadresse.

Vi leverer din ordre fragtfrit til en valgfri GLS pakkeshop, hvis du bestiller for over 399 kr.

Du har mulighed for at vælge afhentning i butik. Når du modtager en mail med at din ordre er færdig pakket, kan den afhentes indenfor vores åbningstider, som er mandag til torsdag 9-17.00 og fredag kl. 9-16.30 på vores adresse Amalienborgvej 57 i Nørresundby.

Vil du vide mere om vores returregler, læs dem her

Vi ser frem til din ordre 😍